Product Details Portlet

EE-SX3148-P1 Photo IC Output Photomicrosensor (Transmissive)

  • A boss on one side enables securing the Sensor with one M2 or M3 screw.
  • Sensor can be installed from either top of bottom of mounting plate.
  • High resolution both vertically and horizontally (slot dimensions: 0.5 x 0.5 mm)
  • 3.6-mm-wide slot.
  • Photo-IC output connects directly to CMOS and TTL devices.
  • Applicable to the ZH and ZR Connector Series from JST (Japan Solderless Terminal).
RoHS Compliant
Note: This web page provides an excerpt from a datasheet. Refer to Product Datasheet and other applicable documents for more information.
Absolute Maximum Ratings (Ta = 25ºC)
ItemSymbolRated value
Power supply voltageVCC6 V
Output voltageVOUT28 V
Output currentIOUT16 mA
Permissible output dissipationPOUT250 mW
(see note)
Ambient temperatureOperatingTopr-20ºC to 75ºC
StorageTstg-40ºC to 85ºC
Soldering temperatureTstg-
Note:Refer to the temperature rating chart if the ambient temperature exceeds 25ºC.

Electrical and Optical Characteristics (Ta = 25ºC, VCC = 5 V ±10%)
Current consumptionICC30 mA max.With and without incident
Low-level output voltageVOL0.3 V max.IOUT = 16 mA
without incident
High-level output voltageVOH(VCC x 0.9) V min.VOUT = VCC with incident
RL = 47 kΩ
Response frequencyf 3 kHz min.VOUT = VCC, RL = 47 kΩ (see note)
Note : The value of the response frequency is measured by rotating the disk as shown below.

Note: All units are in millimeters unless otherwise indicated.

Terminal No.Name
1Power supply
2Output (OUT)
3Ground (GND)
Recommended Mating Connectors:
JST (Japan Solderless Terminal) ZHR-3 Series (crimp connector) 03ZR Series (press-fit connector)

Unless otherwise specified, the tolerances are as shown below.
3 mm max.± 0.200
3 < mm ≤ 6± 0.240
6 < mm ≤ 10± 0.290
10 < mm ≤ 18± 0.350
18 < mm ≤ 30± 0.420